Study summary

Antiseptic Effect of Slightly Acidic Electrolyzed Water on Dental Unit Water Systems

The Bulletin of Tokyo Dental College · 2014

Summary

Abstract

Biofilm formation in dental unit water systems (DUWSs) can contaminate water from three-in-one syringes, air rotors, and low-speed handpieces. This may serve as a potential source of infection for dentists, dental staff, and patients, so these systems must be sterilized. Becaslightly acidic electrolyzed water (SAEW) is often used as a disinfectant for food, the aim of this study was to investigate the possibility of using SAEW as a DUWS disinfectant. Slightly acidic electrolyzed water was injected into a dental unit and its effects evaluated. Chemical properties such as chlorine ion and potential hydrogen in the SAEW were measured. Detection of both ordinary and heterotrophic bacteria from the DUWS was performed by culture, and biofilm formation of the bacteria in the DUWS evaluated. Polymerase chain reaction (PCR) was used to detected contamination by nosocomial pathogens. Almost all the chlorine ions in the SAEW were exhausted during the two-day trials, and the pH value of the SAEW fell from 5 to 4. No viable cells were detected in the SAEW collected. Biofilm formation in the water from the DUWS with SAEW was almost at a baseline level, whereas that without SAEW was 4 times higher. The PCR analysis showed that no nosocomial infecting pathogens were detected in the SAEW. The present study demonstrated the antiseptic effect of SAEW in DUWS.

Study details

  • Published in: The Bulletin of Tokyo Dental College 55.2 (2014): 77-86
  • Microbes studied: Total Microbial Count

Source

Read the original study

Source: The Bulletin of Tokyo Dental College 55.2 (2014): 77-86

Conditions tested

ParameterValue
OrganismsTotal microbial count
PublicationThe Bulletin of Tokyo Dental College, 2014

Reading this responsibly

Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.

Applying it

Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.

Source

View the published study

Turn the evidence into a protocol

We size the system, set the concentration and contact time, write the SOP and assemble the citations — free, and in writing.