Summary
Abstract
Electrolyzed anodic NaCl solutions [EW(+)], prepared by the electrolysis of 0.1% NaCl, have been shown to instantly inactivate most pathogens that cause food-borne disease. Elimination of food-borne pathogens does not necessarily guarantee food safety because enterotoxins produced by pathogens may remain active. We have tested whether EW(+) can inactivate Staphylococcal enterotoxin A (SEA), one of the major enterotoxins responsible for food poisoning. Fixed quantities of SEA were mixed with increasing molar ratios of EW(+), and SEA was evaluated by reversed-phase passive latex agglutination (RPLA) test, immunoassay, native polyacrylamide gel electrophoresis (PAGE), and amino acid analysis after 30 min incubations. Exposure of 70 ng, or 2.6 pmol, of SEA in 25 L of PBS to a 10-fold volume of EW(+), or ca. 64.6 103-fold molar excess of HOCl in EW(+), caused a loss of immuno-reactivity between SEA and a specific anti-SEA antibody. Native PAGE indicated that EW(+) caused fragmentation of SEA, and amino acid analysis indicated a loss in amino acid content, in particular Met, Tyr, Ile, Asn, and Asp. Staphylococcal enterotoxin-A excreted into culture broth was also inactivated by exposure to an excess molar ratio of EW(+). Thus, EW(+) may be a useful management tool to ensure food hygiene by food processing industries.
Study details
- Published in: Journal of agricultural and Food Chemistry 50.1 (2002): 230-234
- Microbes studied: Staphylococcus, Staphylococcal enterotoxin-A
Source
Source: Journal of agricultural and Food Chemistry 50.1 (2002): 230-234
Conditions tested
| Parameter | Value |
|---|---|
| Organisms | Staphylococcus spp. |
| Relevant sectors | Agriculture & Livestock, Food Processing |
| Publication | Journal of agricultural and Food Chemistry, 2002 |
Reading this responsibly
Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.
Applying it
Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.