Summary
Abstract
An electrolytic process based on chlorine generation was adopted to treat wastewater containing textile dyes. In situ production of hypochlorous acid was achieved in an undivided electrolytic cell. The cell contained a graphite rod as the anode and a stainless steel sheet as the cathode. The generated chlorine reacts with water leading to the formation of hypochlorous acid and hydrochloric acid. The resultant hypochlorous acid, being an oxidising agent, oxidises the organic components present in the textile wastewater. In this study, the colour in wastewater containing Procion Navy and Procion Red dyes, respectively, was completely removed after 40 min of electrolysis at a constant current density of 39 mA/cm2 (where the initial dye concentrations were 3700 and 3200 mg/l, respectively). In the case of the Procion Yellow and composite dyes, complete colour removal occurred after 50 min of electrolysis (with initial dye concentrations of 3500 mg/l). Even though colour removal occurred during the electrolysis process, it required up to 180 min of electrolysis to reduce the COD values for the four dyes (Procion Navy, Red, Yellow and the composite) from the initial levels of 4520, 4200, 4170 and 4283 mg/l to 70, 45, 39 and 52 mg/l, respectively. This clearly indicates that the process removes both colour and organic components present in textile wastewater.
Study details
- Published in: Coloration Technology 117.1 (2001): 49-53
- Microbes studied: None
Source
Source: Coloration Technology 117.1 (2001): 49-53
Conditions tested
| Parameter | Value |
|---|---|
| Relevant sectors | Water Treatment |
| Publication | Coloration Technology, 2001 |
Reading this responsibly
Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.
Applying it
Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.