Summary
Abstract
Pre-treatment steps of fresh produce as Saengshik raw materials are followed by initial clean-up, dipping, primary washing, and cutting. Hypochlorous acid solution was applied in the dipping step to reduce natural microflora. Also, procedures were changed by cutting, dipping and then primary washing, and the efficacy of hypochlorus acid was evaluated. Potatoes, carrots, kales, and angelicas were submerged in water or 100 ppm of hypochlorous acid for 5 min. After initial clean-up, the aerobic plate counts of potatoes, carrots, kales and angelicas were 4.7, 5.3, 5.6, and 5.7 log CFU/g, respectively. When samples were submerged into water, it only reduced the population of natural microflora by 0.2 to 1.1 log CFU/g, whereas when treated with hypochlorous acid, it reduced the population by 0.5 to 2.8 log CFU/g. Reductions of natural microflora in green leafy vegetables were more highly achieved than bulbs such as potatoes and carrots. However, the numbers of natural microflora were increased after cutting step. To control the cross contamination at the cutting process, the process was changed as follows: initial clean-up, cutting, dipping in hypochlorous acid, and then primary washing. It showed effective reduction of the population by 2.3 to 3.2 log CFU/g. Hypochlorous acid solution could be useful as a sanitizer for surface washing of fresh vegetables.
Study details
- Published in: Journal of the Korean Society of Food Science and Nutrition 39.4 (2010): 637-642
- Microbes studied: Total Microbial Count
Source
Source: Journal of the Korean Society of Food Science and Nutrition 39.4 (2010): 637-642
Conditions tested
| Parameter | Value |
|---|---|
| Organisms | Total microbial count |
| Relevant sectors | Food Processing, Produce & Packing |
| Publication | Journal of the Korean Society of Food Science and Nutrition, 2010 |
Reading this responsibly
Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.
Applying it
Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.