Summary
Abstract
Definitive identification of free teliospores of Tilletia indica, causal agent of Karnal bunt of wheat, requires polymerase chain reaction (PCR)-based diagnostic tests. Since direct PCR amplification from teliospores has not been reliable, teliospores first must be germinated in order to obtain adequate DNA. We have routinely surface-sterilized teliospores for 2 min with 0.4% (vol/vol) sodium hypochlorite (NaOCl) to stimulate germination and produce axenic cultures. However, we observed that some spores were killed even with a 2-min NaOCl treatment, the shortest feasible duration. Decreasing the NaOCl concentration in our study from 0.4% to 0.3 and 0.2%, respectively, increased teliospore germination, but treatment times longer than 2 min still progressively reduced the germination percentages. In testing alternative methods, we found acidic electrolyzed water (AEW), generated by electrolysis of a weak solution of sodium chloride, also surface-sterilized and increased the rate of T. indica teliospore germination. In a representative experiment comparing the two methods, NaOCl (0.4%) for 2 min and AEW for 30 min increased germination from 19% (control) to 41 and 54%, respectively, by 7 days after treatment. Because teliospores can be treated with AEW for up to 2 h with little, if any, loss of viability, compared with 1 to 2 min for NaOCl, treatment with AEW has certain advantages over NaOCl for surface sterilizing and increasing germination of teliospores of suspect T. indica.
Study details
- Published in: Plant Disease 83.7 (1999): 627-632
- Microbes studied: Tilletia indica
Source
Source: Plant Disease 83.7 (1999): 627-632
Conditions tested
| Parameter | Value |
|---|---|
| Relevant sectors | Agriculture & Livestock |
| Publication | Plant Disease, 1999 |
Reading this responsibly
Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.
Applying it
Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.