Summary
Abstract
The objective of this study was to determine the efficacy of electrolyzed oxidizing (EO) water in reducing natural microbiota on radish seed and sprout during seed soaking and sprouting. EO water with different available chlorine concentrations (ACC, 15, 20, 28, 33 and 40 mg/L) and different pH (2.5, 3.5, 4.5, 5.5 and 6.5) were used to soak radish seeds for 12 h and the surviving population of total aerobic bacteria, yeast and mold, and germination rate were determined. On the other hand, EO water with ACC of 30 and 50 mg/L was applied to spray sprouts during seed sprouting and the antimicrobial efficacy of EO water, as well as length, gross weight and dry weight of sprout were evaluated. The results showed that the population of natural microbiota decreased with increasing ACC of EO water, while no significant difference was observed among EO waters with different pH levels that were applied while soaking the seeds. EO water with higher ACC and lower pH slightly reduced the germination percentage of radish seed during seed soaking. EO waters with ACC of 30 and 50 mg/L sprayed during seed sprouting resulted in 1.39 and 1.58 log reductions of total aerobic bacteria, yeast and mold, respectively, and improved the length, gross weight and dry weight of the sprouts. Therefore, EO water with low ACC and near neutral pH could be used to soak seeds and water sprouts throughout seed germination and sprouting to control the population of natural microbiota on seeds and sprouts.
Study details
- Published in: Food Control 67 (2016): 177-182
- Microbes studied: Total Microbial Count, Fungi, Yeast, Mold
Source
Source: Food Control 67 (2016): 177-182
Conditions tested
| Parameter | Value |
|---|---|
| Organisms | Fungi (general), Total microbial count |
| Relevant sectors | Food Processing, Produce & Packing |
| Publication | Food Control, 2016 |
Reading this responsibly
Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.
Applying it
Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.