Study summary

A novel electrochemical device as a disinfection system to maintain water quality during washing of ready to eat fresh produce

Food Control · 2017

Summary

Abstract

Electrolyzed water (EW) is known by its bactericidal efficacy and capability to oxidize organic matter. The present research evaluated the efficacy of recently developed electrolytic cells able to generate higher concentration of reactive oxygen species using lower power and salt concentration than conventional cells. This study tested the inactivation of Escherichia coli O157:H7, the organic matter depletion and trihalomethane (THM) generation by EW in process wash water under dynamic conditions. To achieve this, clean tap water was continuously added up to 60 min with artificial process water with high chemical oxygen demand (COD) inoculated with E. coli O157:H7, in experiments performed in a pilot plant that recirculated water through one electrolytic cell. Plate counts of E. coli O157:H7, COD, THMs, free, combined and total chlorine, pH, temperature and oxidation-reduction potential were determined. Results indicate that the novel electrolysis system combined with minimal addition of NaCl (0.05) was able to suppress E. coli O157:H7 population build-up and decreased the COD accumulation in the process wash water. THM levels in the water were relatively high but its concentration in the washed product was marginal. Highly effective electrolysis has been proven to reduce the occurrence of foodborne diseases associated to cross-contamination in produce washers without having an accumulation of THMs in the washed product.

Study details

  • Published in: Food Control 71 (2017): 242-247
  • Microbes studied: Total Microbial Count

Source

Read the original study

Source: Food Control 71 (2017): 242-247

Conditions tested

ParameterValue
OrganismsTotal microbial count
Relevant sectorsFood Processing, Produce & Packing
PublicationFood Control, 2017

Reading this responsibly

Published figures are obtained under controlled conditions, usually on clean surfaces or in defined matrices. Organic load, surface condition, temperature and application coverage all affect real-world performance. Use these numbers to design a protocol, then validate it on your own site with environmental swabbing.

Applying it

Concentrations in this range are within the adjustable output of every EcoloxTech commercial system, so implementing this protocol is a settings question rather than a procurement one. Where the claim needs to sit on a registered label, see HOCl-AS200, EPA Reg. No. 101112-1.

Source

View the published study

Turn the evidence into a protocol

We size the system, set the concentration and contact time, write the SOP and assemble the citations — free, and in writing.